SPONSORED BY FULL THROTTLE PERFORMANCE PARTS

"PROJECT VIPER"

This is a list of all the MOD's I have done to the car.
All of those MOD's were found on the internet. From V6 sites. Please feel free to email, post in the guest book, for any questions you may have. More info and pictures can be found on the PHOTO PAGE.


The motor about ready to be put back in.
This is after many hours of prep work. Take note of the P/P heads from Force Fed Fabs. I painted the valve covers and ready to put the stage 5 clutch on.
 
Still a lot of work to go. Much tuning to do when the turbo is installed.

In July 2004 I put the built motor in and got it running, the turbo had not come in so it's running NA for the moment and with the injectors it was running rich and fouling plugs every 25-50 miles. I then installed the MSD DIS-4 and 400 miles no fouled plugs.  

MOD LIST
Motor
Diamond coated piston 8.5:1 c/r w/rings and wrist pins www.3800performance.com
Forged L32 2004 GTP Connecting Rods www.3800performance.com
ARP studs, bolts ect.
Intense racing head gaskets  www.3800performance.com
Comp Cams custom grind,  www.3800performance.com
Comp cams Hydraulic Roller Lifters  www.3800performance.com
Comp cams 130lb springs  www.3800performance.com
Comp cams titanium retainers  www.3800performance.com
Comp cams push rods www.3800performance.com
Cam install kit w/timing chain www.3800performance.com
Clevite 77 TriMetal Main Bearings
Clevite 77 TriMetal Rod Bearings
Clevite 77 TriMetal Cam Bearings
Oil PSI kit to 80 PSI at WOT www.intense-racing.com
New oil pump kit 

Mobil 1 15w50 & K&N Oil filter

PCM
HP Tuners PCM Programmer
Greddy Black Profec B-Spec II electronic boost controller www.ftpp.net **Wating to Install**

FUEL
57 lb/hr injectors  http://www.racetronix.com/
********WAITING TO ORDER************
Racetronix Fuel pump kit http://www.racetronix.com/Racetronix-F-body_LT1_Pump_Kit.html

Induction
T-70 Force Fed Fabs Turbo kit   http://www.force-fed-fabrications.com *****Road Trip for install soon****
Race port/polish heads w 5/3 angle valve job
 
K&N air filter


Exhaust
Pacesetter headers www.ftpp.net
Open down pipe


Ignition

MSD Heat Guard Kit www.ftpp.net
MSD DIS 4  www.summitracing.com
MSD Custom Wires  www.summitracing.com
MSD Blaster coils  www.summitracing.com
MSD Coil Interface Modules  www.summitracing.com


Gauges
A/F ratio www.summitracing.com
Boost  www.summitracing.com
Fuel PSI   www.summitracing.com                     
Digital RPM gauge with LED shift light built in  http://www.sw-performance.com/Prods/11UltrShft.html
AEM 2 1/16" Wide Band AFR www.ftpp.net

Outside
Smoothie II's wrapped in Eagle F1 GS-D3 275/40ZR-17's  
Light black outs all the way around
Viper yellow with black racing stripes
Mud/rubber flaps with "CAMARO" on Rear only
"Camaro" rear inserts
3800 side stickers
30th Ann stickers

 
Inside
Custom painted Yellow by me
White face/ reverse glow gauges www.ebay.com
Peddles
Corbeau adj.racing seat (yellow) 

Corbeau black 5-point harness. www.ftpp.net
Corbeau seat mounting brackets. www.ftpp.net

*******WAITING TO INSTALL*****************
Autometer 3 gauge pillar pod www.ftpp.net

System
Panasonic 60w * 4 w/ 3dot matrix display
Kenwood 1000w RMS amp www.ebay.com
2 reference Infinity 12's www.ebay.com 
Kicker components
3 Farad CAP www.ebay.com


Drive Train
Prothane Tranny mount www.summitracing.com
Z28 Rear End/axles/brakes www.camaroz28.com
LS1 1 piece Drive Shaft www.camaroz28.com
STAGE-5 SPEC Clutch www.ftpp.net
Mobil 1 Tranny and rear-end fluid.

 

Suspension  ******* waiting to order****/^^^^and/or install^^^^^
KYB AGX 8 way Adj. shocks on front and rear
New rear spings
Spohn 8 point roll bar.  www.ftpp.net  (Door bar's not installed yet)
Spohn LCA w/install www.ftpp.net
Spohn TQ Arm w/DS loop www.ftpp.net ******
Spohn Pan Hard Bar w/install kit www.ftpp.net *******

Brakes
Hawk HPS pads both front and rear. www.ebay.com
Cross drilled/slotted rotors both front and rear. www.irotors.com
Rear Disk Brake's www.ebay.com  

Email me if you have any Questions.

Motor Picture


Since upper intake was off to install the motor I found some paint just sitting at the store :)

I  painted it with 500* motor paint. 4 coats later its looking great.



Clutch is on but only for the picture. Forgot to replace the carrier bearing. Whoops hammer and screw driver save trip to the store for the puller ;-)
So why does spec make the clutch Blue if you can't see it unless you drop the Tranny....??? Good thing because it doesn't match the car.. lol

 

You are the 6620 Visitor to the page.